1. Corrections to "Targeted Microbubble Mediated Sonoporation of Endothelial Cells In Vivo"
Ilya Skachkov, Ying Luan, Antonius F W van der Steen, Nico de Jong, Klazina Kooiman IEEE Trans Ultrason Ferroelectr Freq Control. 2021 Jun;68(6):2320.doi: 10.1109/TUFFC.2021.3064763.Epub 2021 May 25.
In the above article [1], the authors regret that there was a mistake in calculating the mol% of the microbubble coating composition. For all experiments, the unit in mg/mL was utilized and the conversion mistake only came when converting to mol% in order to define the ratio between the coating formulation components. The correct molecular weight of PEG-40 stearate is 2046.54 g/mol [2], [3], not 328.53 g/mol. On page 1661, paragraph II-A, it should read "The coating was composed of DSPC (84.8 mol%; P 6517; Sigma-Aldrich, Zwijndrecht, The Netherlands);PEG-40 stearate (8.2 mol%; P 3440; Sigma-Aldrich); DSPE-PEG(2000) (5.9 mol%; 880125 P; Avanti Polar Lipids, Alabaster, AL, USA); and DSPE-PEG(2000)-biotin (1.1 mol%; 880129 C; Avanti Polar Lipids)".
2. Biotinylated lipid bilayer disks as model membranes for biosensor analyses
Anna Lundquist, Søren B Hansen, Helena Nordström, U Helena Danielson, Katarina Edwards Anal Biochem. 2010 Oct 15;405(2):153-9.doi: 10.1016/j.ab.2010.06.030.Epub 2010 Jun 19.
The aim of this study was to investigate the potential of polyethylene glycol (PEG)-stabilized lipid bilayer disks as model membranes for surface plasmon resonance (SPR)-based biosensor analyses. Nanosized bilayer disks that included 1,2-distearoyl-sn-glycero-3-phosphoethanolamine-N-[biotinyl(polyethylene glycol)(2000)] (DSPE-PEG(2000)-biotin) were prepared and structurally characterized by cryo-transmission electron microscopy (cryo-TEM) imaging. The biotinylated disks were immobilized via streptavidin to three different types of sensor chips (CM3, CM4, and CM5) varying in their degree of carboxymethylation and thickness of the dextran matrix. The bilayer disks were found to interact with and bind stably to the streptavidin-coated sensor surfaces. As a first step toward the use of these bilayer disks as model membranes in SPR-based studies of membrane proteins, initial investigations were carried out with cyclooxygenases 1 and 2 (COX 1 and COX 2). Bilayer disks were preincubated with the respective protein and thereafter allowed to interact with the sensor surface. The signal resulting from the interaction was, in both cases, significantly enhanced as compared with the signal obtained when disks alone were injected over the surface. The results of the study suggest that bilayer disks constitute a new and promising type of model membranes for SPR-based biosensor studies.
3. Corrections to "Vibrational Responses of Bound and Nonbound Targeted Lipid-Coated Single Microbubbles"
Tom van Rooij, Ines Beekers, Kirby R Lattwein, Antonius F W van der Steen, Nico de Jong, Klazina Kooiman IEEE Trans Ultrason Ferroelectr Freq Control. 2021 Jun;68(6):2319.doi: 10.1109/TUFFC.2021.3064751.Epub 2021 May 25.
In the above article [1], the authors regret that there was a mistake in calculating the mol% of the microbubble coating composition. For all experiments, the unit in mg/mL was utilized and the conversion mistake only came when converting to mol% in order to define the ratio between the coating formulation components. The correct molecular weight of PEG-40 stearate is 2046.54 g/mol [2], [3], not 328.53 g/mol. On page 786, paragraph II-A, it should read "The coating was composed of 84.8 mol% DSPC (P6517, Sigma-Aldrich, Zwijndrecht, The Netherlands) or DPPC (850355, Avanti Polar Lipids, Alabaster, AL, USA); 8.2 mol% polyoxyethylene-40-stearate (PEG-40 stearate, P3440, Sigma-Aldrich); 5.9 mol% 1,2-distearoyl-sn-glycero-3-phosphoethanolamine-N-[carboxy(polyethylene glycol)-2000] (DSPE-PEG(2000), 880125, Avanti Polar Lipids); and 1.1 mol% 1,2-distearoyl-sn-glycero-3-phosphoethanolamine-N-[biotinyl(polyethylene glycol)-2000] (DSPE-PEG(2000)-biotin, 880129, Avanti Polar Lipids)."
